DIY Guide: How to Paint Bathrooms

Painting a bathroom may seem easy, but it isn’t. Bathrooms are in contact with moisture and pathogens. So, stubborn stains tend to appear very easily on the surface of ceilings and walls.

If you don’t use the right kind of paint, your bathroom could end up filled with horrible dark stains after a while. Removing these stains isn’t easy and you’ll certainly need to scrub a lot to remove them.

If you don’t want that to happen to you, pay close attention. In this article you’ll learn how to choose the best type of paint for your bathroom. In addition, you’ll find several tips to get the most out of your paint and painting tools.

Bathroom Paint Kit List

Before you start painting your bathroom, you’ll need the right tools and materials to get the best results. Here’s a list of what you’ll need:

Bathroom Paint

Bathroom paint is a special type of paint that forms a waterproof film on the surface. This allows water droplets to easily slip on ceilings and walls and then evaporate. In addition, bathroom paint contains antifungal and antibacterial compounds that prevent stains and bad odors.

Painting Tray

A painting tray is a flat container for pouring paint. Painting trays are especially useful when working with paint rollers. They allow for a uniform dosage of paint on the roller. This way, the paint is evenly spread on the surface.

Paint Rollers

Paint rollers are tools that serve to paint surfaces. They usually consist of a hollow cylinder and a handle. The cylinder is covered with a padded material that absorbs the paint. The paint is evenly spread when the roller is slid on the surface.

Paint Brushes

Brushes are tools that serve to paint surfaces. However, a clean brush also serves to remove dust. Brushes use a series of bristles to spread the paint. Brushes are available in a wide variety of sizes. The larger ones are used to paint large areas. The smallest can reach difficult corners.

Joint Compound

It’s a thick substance that serves to fill holes in walls and ceilings. Joint compound is a mixture of limestone, water, polymers and other ingredients. When it dries, it becomes hard. However, it can be easily sanded using any type of sand paper.

Step by Step DIY Guide to Paint a Bathroom

Many people think that painting a bathroom is like painting any other room in the home. But no. When painting a bathroom, you’ll need to follow some basic steps to get lasting results. Below, you’ll find a detailed explanation of how to paint a bathroom the right way.

1 First of all, choose an appropriate paint type for your bathroom.

2After that, cover the entire bathroom floor with plastic sheeting.

3Then, clean the ceilings and walls. Use joint compound and sand paper to correct any imperfections on the surface.

4Cover those areas that don’t need to be painted with paper tape.

5Then, open the paint can and mix the paint evenly. You can use a wooden stick to do this.

6Depending on the result you want to obtain, use a paint roller or a brush to paint walls and ceilings. Apply two coats of paint if necessary.

7Wait for the paint to dry.

8Then, carefully remove the paper tape and plastic sheeting. Finally, correct the small defects in the paint using a small brush.

Conclusion

Certainly, not all types of paint work well in bathrooms. Therefore, you must verify that the paint is specially formulated for these purposes. Also make sure to follow the steps outlined in this guide one by one. That way, you’ll get the best results and your walls will look perfect for longer.